MOOSE RACING Water Pump Rebuild Kit 821328MSE Taillight and License Plate Holder with Turn Signal Complement your home

Complement your home

while allowing more airflow than two separate layer filters (flow bench proven) Twin Air filters are slightly smaller than stock to make them easier to change and to increase dead air space around the filter for better performance

Merged the 1-7/8" head pipes into a large 2-1/4" collector that steps up to a 2-1/2" perforated core Core wrapped in stainless steel screen then encloded in fiberglass pillow Collector covered by large one-piece heat shield that is held in place with two clamps and stamped Cobra logo 4" muffler body capped with a 4" machined aluminum dual-cut tip that features small alluvial flutes Body arrives pre-set in slight upward position Works wtih stock or extended bags

2010-2016 Honda VT1300CR Stateline - - 2010-2016 Honda VT1300CS Sabre - - 2010-2016 Honda VT1300CX Fury - -

MOOSE RACING Water Pump Rebuild Kit 821328MSE Taillight and License Plate Holder with Turn Signal Complement your homeInclude every gasket, O ring, bearing and seal required to rebuild a water pump Typical kit includes the following: bearings where applicable; rubber seals; mechanical water pump seal where applicable; side cover gasket; water pump gasket; snap rings located on water pump shaft and copper drain washers